![]() Its a rotary switch thats about 1/2" in diameter and is not much more than just a knob. 3) search around and find switches like the one I've posted here. I'm not sure the insulators are necessary for heat, as the pipe is pretty thick, but I was worried about conductivity since the metal shell of the socket is actually the negative power for the lightbulb. ![]() My local hardware store had these as well as really thin cardboard insulators that made the whole thing a perfect fit. You need one that is basically no bigger than the metal threaded part (also known as the shell). ![]() You might have to look around at different stores for the socket though. 2) If you're using 1/2" pipe, you can get a 1/2" to 1" reducer piece that fits a regular sized light socket well. After assembling everything I went to a decent local hardware store the other day and discovered that their black iron was about half the cost of HD. I figured since they're a large chain that their black iron pipe would be cheapest. I made a couple of these this weekend for my girlfriend and have a few tips if anyone is going to try this ible: 1) don't go to Home Depot. Let me know if you have any other issues! It's not perfect but it works pretty well. What I ended up doing is wrapping the white part of the switch with red ductape until it fit snuggly inside of the pipe opening. I then sprayed the white part with red spray paint to match.Īnother tricky part (after getting them glued) is to keep them in the pipe without falling out but still having enough wiggle room to turn. It has amazing holding power even on slick parts (case in point: I got some on my stainless steel metal sink and it is still there, a year and a half later, bonded straight to the slick metal). I put pieces of my car back together with this stuff though. I think no one knows about it because it's been around forever and goes under the radar. But J & B weld is seriously underrated and amazing. I've tried epoxy glues, craft glues, gorilla glue etc. I think the info you're looking for is this: use J & B weld. You probably already got all that, I just wanted to clarify. The white part is the on/off switch (rotates on then off). ![]() It's not actually a "valve" just the knob. If you look at the first photo I attached, you can see that the faucet is literally just the handle. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |